Wasp-bar-code WWS800 Bedienungsanleitung Seite 1

WWS800/850 Bluetooth Wireless Scanners User’s Manual WARNING This equipment has been tested and found to comply with th

13the scanner is out of signal range and data will transmitted to server when the scanner is back to the service range. The WWS800/850 can work offli

15the initial (first time) connection setup, this setting must be enabled. User can disable this setting for security reasons after initial connectio

176.1.2 Reset Connection Scan the “Reset Connection” when switch connection from one PC to another PC. The scanner will re-start itself after this ba

19 6.3 Configuring Bluetooth Device Driver Please follow the procedures below to configure the Bluetooth driver on the host system. Please note t

21 8. The scanner is ready to use. Please click OK button. 6.3.2 Widcomm Bluetooth Driver 1. Click icon at PC. 2. Click Find Bluetooth De

236. Click PC Remote Commander icon. 7. Click Yes Button. 8. When the green arrow icon is displayed, the connection is ready.

25• Checksum Transmission: This parameter specifies whether the checksum character is included in the data being transmitted. • Code Length Qualifi

27• Checksum Verification: Three kinds of checksum calculations can be implemented into MSI code: Single Modulo 10, Double Modulo 10, or Modulo 11

298. Data Output Format Data read by the scanner will be processed in the following sequence (RS-232, Keyboard Wedge and USB interfaces). 1) The ch

319. Data Editing The WWS800/850 scanner provides advanced data editing functions for data formatting. Data editing is performed according to user c

Table of Contents 1. INTRODUCTION...1 2. BASE INSTALLATION .

33always included in the field. User though, has the option of discarding this terminating string. • Field Length: The field division can be simply

3510. Configuring your WWS800/850 The configuration of WWS800/850 Scanner is done by reading the setup labels contained in the Configuration Manual

37used. These parameters are: Prefix Code, Postfix Code, Code ID, and Additional Fields of Editing Formats. The available key type/status settings c

8. DATA OUTPUT FORMAT...29 8.1 CHARACTER SUBSTITUTION...

11. Introduction This manual described how to operate and configure the WWS800/850 Wireless Barcode Scanner and is divided into two sections. The fi

32.2 Power Up the WWS800/850 When you receive your WWS800/850, the battery will be packaged separately. Please insert the battery into the bottom

5 2.4.3 DC Jack Insert the power supply to the DC Jack at bottom of the scanner. When char

7• Continuous Mode: The scanner is always scanning. • Auto Power Off Mode: The scanner will start scanning once the switch is triggered. The scanni

9• EAN8 (with or without Addon) • EAN13 (with or without Addon) • Code 93 • Code 128 • EAN 128 • MSI • Telepen • Plessey 3.9 Negative Barcode

11 4.1.4 Capital Lock Status In order to send alphabets with correct case, the scanner needs to know the capital lock status of the keyboard. Incorr